Juniper 인증 JN0-692 덤프

ITExamDump의 도움으로 여러분은 많은 시간과 돈을 들이지 않으셔도 혹은 여러학원등을 다니시지 않으셔도 우리 덤프로 안전하게 시험을 통과하실 수 있습니다.Juniper JN0-692시험자료는 우리 ITExamDump에서 실제시험에 의하여 만들어진 것입니다. 지금까지의 시험문제와 답과 시험문제분석 등입니다. ITExamDump에서 제공하는Juniper JN0-692시험자료의 문제와 답은 실제시험의 문제와 답과 아주 비슷합니다.

ITExamDump에서 Juniper인증 JN0-692덤프를 구입하시면 퍼펙트한 구매후 서비스를 제공해드립니다. Juniper인증 JN0-692덤프가 업데이트되면 업데이트된 최신버전을 무료로 서비스로 드립니다. 시험에서 불합격성적표를 받으시면 덤프구매시 지불한 덤프비용은 환불해드립니다.

ITExamDump의Juniper JN0-692인증시험의 자료 메뉴에는Juniper JN0-692인증시험실기와Juniper JN0-692인증시험 문제집으로 나누어져 있습니다.우리 사이트에서 관련된 학습가이드를 만나보실 수 있습니다. 우리 ITExamDump의Juniper JN0-692인증시험자료를 자세히 보시면 제일 알맞고 보장도가 높으며 또한 제일 전면적인 것을 느끼게 될 것입니다.

Juniper인증 JN0-692시험취득 의향이 있는 분이 이 글을 보게 될것이라 믿고ITExamDump에서 출시한 Juniper인증 JN0-692덤프를 강추합니다. ITExamDump의Juniper인증 JN0-692덤프는 최강 적중율을 자랑하고 있어 시험패스율이 가장 높은 덤프자료로서 뜨거운 인기를 누리고 있습니다. IT인증시험을 패스하여 자격증을 취득하려는 분은ITExamDump제품에 주목해주세요.

Juniper인증JN0-692시험을 위하여 최고의 선택이 필요합니다. ITExamDump 선택으로 좋은 성적도 얻고 하면서 저희 선택을 후회하지 않을것니다.돈은 적게 들고 효과는 아주 좋습니다.우리ITExamDump여러분의 응시분비에 많은 도움이 될뿐만아니라Juniper인증JN0-692시험은 또 일년무료 업데이트서비스를 제공합니다.작은 돈을 투자하고 이렇게 좋은 성과는 아주 바람직하다고 봅니다.

시험 번호/코드: JN0-692
시험 이름: Juniper (Service Provider Routing and Switching Support, Professional)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 171 문항
업데이트: 2014-01-23

우리ITExamDump의 덤프는 여러분이Juniper JN0-692인증시험응시에 도움이 되시라고 제공되는 것입니다, 우라ITExamDump에서 제공되는 학습가이드에는Juniper JN0-692인증시험관연 정보기술로 여러분이 이 분야의 지식 장악에 많은 도움이 될 것이며 또한 아주 정확한Juniper JN0-692시험문제와 답으로 여러분은 한번에 안전하게 시험을 패스하실 수 있습니다,Juniper JN0-692인증시험을 아주 높은 점수로 패스할 것을 보장해 드립니다,

JN0-692 덤프무료샘플다운로드하기: http://www.itexamdump.com/JN0-692.html

NO.1 Your currently configured regular expression does not match the AS path shown below:
2135.55 55 55 55 3796
Which three regular expressions would match this path? (Choose three.)
A. "."2135"
B. "2135.*"
C. "* 55(1, 3) *"
D. "2135 55(5) 3796"
E. "2135 55(1, 2) 3796"
Answer: B,C,E

Juniper pdf   JN0-692   JN0-692

NO.2 Your OSPF network includes an NSSA. Which LSA type is injected into the NSSA by the ASBR?
A. Type 3
B. Type 5
C. Type 7
D. Type 9
Answer: C

Juniper   JN0-692   JN0-692   JN0-692   JN0-692인증

NO.3 You recently added your autonomous system to an existing BGP confederation. You notice that
a route that had a local preference of 100 now has a local preference of 50. Which statement
explains the change?
A. BGP path attributes such as next hop, local preference, and MED are normally restricted to a
single AS but are allowed to propagate throughout the confederation's AS members.
B. The confederation has sub-ASs that require all IBGP routes to have a local preference of 50 or
below.
C. When your Junos devices joined the confederation, they lost IBGP connectivity to the route in
question; the local preference reverted to 50 once the BGP peering established.
D. The route is being shared through an EBGP peer, and the confederation is propagating the local
preference from the peer.
Answer: A

Juniper dumps   JN0-692 dump   JN0-692

NO.4 An OSPF neighbor between routers R1 and R2 is stuck in loading state on R2. What are two
causes? (Choose two.)
A. OSPF is not enabled on the interfaces.
B. A firewall filter is blocking OSPF hellos on both sides.
C. The R1 router has received a corrupted link-state request packet.
D. The interface MTU is mismatched between the routers.
Answer: C,D

Juniper인증   JN0-692 pdf   JN0-692자격증   JN0-692   JN0-692인증

NO.5 You have recently implemented a new Layer 2 VPN and it is not establishing. The show I2vpn
connections command displays an out-of-range state.
What is causing this problem?
A. The local site ID value is too high for the label block.
B. The VRF target community values do not match between sites.
C. The VRF route distinguisher values do not match between sites.
D. The local site ID is not defined.
Answer: A

Juniper dumps   JN0-692최신덤프   JN0-692 dump

NO.6 You have recently added LDP-signaled VPLS to your network. The VPLS connections are
established and you have been asked to verify that the forwarding plane is working properly. Which
three commands would you use? (Choose three.)
A. ping mpls Idp <fec>
B. show vpls connections
C. traceroute mpls Idp <fec>
D. show vpls mac-table
E. show Idp statistics
Answer: A,C,D

Juniper pdf   JN0-692덤프   JN0-692
10. R1 and R2 are IS-IS Level 1 routers, but are not forming an adjacency.
Which two reasons would account for this happening? (Choose two.)
A. The remote router is configured for both IPv4 and IPv6.
B. The remote router does not have family iso enabled on its interface,
C. The remote router does not have family clns enabled on its interface.
D. The remote router is not configured to participate in the same Level 1 area
Answer: B,D

Juniper dump   JN0-692   JN0-692   JN0-692인증

NO.7 One of your router's OSPF adjacencies is down.
What are three reasons for this adjacency state change? (Choose Three)
A. A filter has just been configured on one of the OSPF routers.
B. The OSPF hello value is the same on both routers.
C. The controlling BFD session state has gone down.
D. The authentication key on both routers matches.
E. One of the physical interfaces has gone down.
Answer: A,C,E

Juniper   JN0-692덤프   JN0-692   JN0-692   JN0-692기출문제

NO.8 You are asked to retain several routes from an external BGP neighbor in the routing table on
your local router, but you are not allowed to forward traffic to these destinations. You have
configured a forwarding table firewall filter to block these routes, and applied it under the (edit
forwarding-options] hierarchy, but the routes are still showing up in the forwarding table. What is
required to achieve this task?
A. Configure an EBGP import policy on your local router to block the routes.
B. Have the EBGP neighbor configure an export policy to block the routes.
C. Configure an export policy for the forwarding table to block the routes.
D. Use the no-install configuration statement within the EBGP neighbor group on your local router.
Answer: C

Juniper pdf   JN0-692   JN0-692 dump   JN0-692인증   JN0-692

NO.9 You have applied a customized EXP rewrite rule on router R1 on the egress of the interface
connecting to router R2. You want to verify if it is working properly. Which two methods would you
use to accomplish this task? (Choose two.)
A. Apply a rewrite rule on the ingress of R2 for packets coming in from R1 and count those packets
for the new EXP values with a firewall filter as they leave R2.
B. Use the traceroute utility.
C. Use an output filter on R1 that matches and counts on various EXP values on packets going to R2.
D. Use an input firewall filter on R2 that matches and counts on various EXP values on packets
coming from R1.
Answer: C,D

Juniper   JN0-692   JN0-692   JN0-692기출문제

ITexamdump의 1z0-460덤프의 VCE테스트프로그램과 MB5-705덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 1Z0-807시험에 대비한 고품질 덤프와 MB6-871시험 최신버전덤프를 제공해드립니다. 최고품질 100-101시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.

시험자료링크: http://www.itexamdump.com/JN0-692.html